Step One
Mark out a circle on a piece of wood (12cms in diameter) and cut out using your Dremel 300 multi-tool, SpeedClic mandrel, spiral bit and line and circle cutter attachment. Then repeat to create a smaller wood circle (5cms in diameter). Then, cut seven lengths of bamboo (three x 30cms, three x 36cms, one x 10cms in length) using the multi-tool and wood cutting wheel.
Next, insert wood drill bit no: 4 into your Dremel 300 and drill six, equally spaced holes around the edge of the larger wood circle, two in the middle and another four holes set 2 cms in - for hanging the finished set of chimes.
Then, drill two holes through the middle of the smaller wood circle and two threading holes through each side at the top of the six lengths of bamboo and one through the top of the small bamboo piece.
Step Two
Cut away and shape the lower half of the bamboo pieces. Then, use a pen to draw your designs on each piece of bamboo and mark lines round the edges of the two wood circles.
Step Three
Insert the woodburning tip in the Dremel Versatip and burn your design onto the bamboo and the lines around the wood circles.
Step Four
Use cord to thread the small wood circle and small length of bamboo through the centre of the larger wood circle. Thread the longer bamboo lengths around the outside, then thread the four hanging holes and ensure the chimes hang evenly.
Difficulty rating :
*** 3 stars (moderate)
Materials required :
Dremel 300 Series multi-tool
SpeedClic mandrel SC402
SpeedClic wood cutting wheel SC544
Line and Circle Cutter Attachment 678
Spiral bit 561
Wood drill bits 636
Dremel Versatip with woodburning tip
Wood
Lengths of bamboo
Marker pen
Threading cord
For more information visit the Dremel website: www.dremel.co.uk
No comments:
Post a Comment